ORTUR Obsidian 3D Drucker Firmware

Hier hat man die Möglichkeit die aktuellste Firmware für den ORTUR Obsidian fertig zum Flashen herunterzuladen.

  • Enable BABYSTEP_ZPROBE_OFFSET // Combine M851 Z and Babystepping
  • Modified the control interface of the power module
  • Optimize power outage detection and Power loss recovery
  • Optimize automatic leveling process.
  • Add probe Z-Offset automatic detection.
  • Fix long click failure problem on touch screen
  • Add Touch calibration menu
  • Add interference filter for filament runout detection
  • Diese Firmware hat eine neue GUI
  • Optimized unnecessary interface performance waste.
  • The auto-leveling screen has been added with a message box asking if z-Offset needs to be automatically detected
  • Add a screensaver to the screen during printing. Increase the life of the screen and avoid white screen failure.
  • Fixed an issue where you couldn’t adjust the brightness of the light.
  • Fixed a problem where the fan could only rotate at 100% speed.
  • Fixed an issue where heating may fail at 110 degrees in winter.
  • Optimize the automatic leveling process, and let the machine automatically detect the Z-OFFSET value.
  • Fixed an issue where heating might stop during printing.